Can I Solder or Weld to Neodymium Magnets?

Short answer

No. Soldering and welding heat a magnet far beyond what it can survive. Standard N-grade neodymium magnets start to lose strength permanently above 80°C (176°F), and around their Curie temperature of roughly 310°C (590°F) they lose their magnetism completely. Use epoxy or a mechanical mount such as screws, a pot magnet or a pocket instead.

Temperatures Compared

Typical Values in °C. Solder and Welding Temperatures Are Approximate.

N-Grade Magnet Limit80°C (176°F)
SH-Grade Magnet Limit150°C (302°F)
Lead-Free Solder Melts~220°C (428°F)
Neodymium Curie Temperature~310°C (590°F)
Soldering Iron Tip~340°C (644°F)
Welding (Melts Steel)1,500°C+ (2,700°F+)

Better Ways to Attach a Magnet

Two-Part Epoxy

The strongest bond for most materials. See how to glue magnets.

Screws

Countersunk magnets mount with a flat-head screw.

Threaded Studs

Threaded pot magnets have a built-in stud or screw hole.

Press Fit

A snug pocket or clip holds a magnet with no heat at all.

Need a Magnet Near Heat?

If your part runs hot, ask about higher-temperature grades such as SH, which are rated to 150°C (302°F). See can temperature affect neodymium magnets?