3/4 x 1/4 Inch Neodymium Rare Earth Countersunk Ring Magnets N52 (6 Pack)

3/4 x 1/4 Inch N52 neodymium countersunk ring magnets, nickel-plated, in two stacks, countersunk holes facing out

3/4 x 1/4 Inch Neodymium Rare Earth Countersunk Ring Magnets N52 (6 Pack)

  • $ 22.79 USD $23.79


✓ In Stock - Ships Free Within 1 Business Day

Buy More and Save up to 35%
Quantity of Packs Price per Pack Discount
Buy 2 $21.66/pack 5% Off
Buy 3 $20.52/pack 10% Off
Buy 5 $19.38/pack 15% Off
Buy 10 $18.24/pack 20% Off
Buy 25 $17.10/pack 25% Off
Buy 50 $15.96/pack 30% Off
Buy 100 $14.82/pack 35% Off
Need more than 100 packs? Email us for a quote.


Magnet Specifications

Imperial Size 0.75 x 0.25 Inch (Outer Diameter x Thickness)
Metric Size 19.05 x 6.35 mm (Outer Diameter x Thickness)
Countersunk Hole Size 0.295 x 0.17 Inches at 82°
Countersunk Hole Location Both Sides (Double Countersunk)
Screw Size #6
Material Grade N52
Pull Force 18.8 lbs
Coating Nickel-Copper-Nickel (Ni-Cu-Ni)
Magnetization Direction Axially
Magnet Material Sintered Neodymium (NdFeB)
Tolerance +/- 0.004 Inches
Max Operating Temperature 80°C / 176°F
Flux Density (Br) 14,800 Gauss
Magnet Weight 12.9 Grams
Part Number DCS34X14N52-6PK
Quantity Included 6 Countersunk Ring Magnets

Produced in an ISO 9001 Facility
Manufactured to Meet RoHS & REACH Standards



Installing Countersunk Magnets: Snug, Not Tight

Tighten each screw only until its head sits flush with the magnet, then stop. Neodymium is hard but brittle, so it can't flex like a steel washer. Once the screw head seats, every extra turn wedges it deeper into the countersink and can crack the magnet around the hole.

Use #6 flat-head screws. Avoid pan-head and round-head screws, which press on the thin edge of the hole.

Drive the screw by hand when you can. If you use a drill/driver, set the clutch to a low number, drive slowly, stop about one turn early and finish by hand. Don't use an impact driver or drill mode. Mount the magnet on a flat surface over a pilot hole, because a bump or glue drip underneath can crack it as you tighten.

Learn more:
How Do I Install Countersunk Magnets Without Breaking Them?
Can I Use Metric and Imperial Screws Interchangeably With Countersunk Magnets?

Dimensions are nominal; see the drawing for tolerances. STEP files open in SolidWorks, Fusion, Onshape, FreeCAD and most other CAD software.